IAD SERIES USERS MANUAL
76
Do not power off during resboot.
Network communication will be temporarily interrupted
during resboot.
7.8 Restore Factory Default
Run Restore Factory Default, all the setting information of the product will be deleted and return to the
factory default configuration status. This function is generally used when the equipment is changed from one
network environment to another different network environment. The device is restored to the factory default
configuration and then reset to better suit the current networking.
Select "System > Restore" and go to " Restore" page as shown in Figure7-12.
Figure
7
- 12
Restore Factory Default
User will lose configuration when restore to the factory
default. Please backup before the restore.
After restoring to the factory default, the system will
resboot.
Step 2 Select the diagnostic tool needed and enter the IP addr or Domain Name of the destination device in the
Diagnostic Address text box.
Step 3 Click the “Run”button to start the debug.
Result
The result will be displayed in the text box below.
7.9 System Debug
This product provides four kinds of diagnostic tools which include ping communication test, TraceRoute
(route tracking), httpGet and DnsQuery. The Ping function is used to test whether the connection between the
product and other network devices is normal or not. The TraceRoute function is used to test whether the link
between the product and a computer or network device is normal. The HttpGet function is used for testing
whether users of this product can access the Internet normally or not; DnsQuery function is used to test
whether the server is valid.
Step 1 Select “System > Debug” to enter “Debug” page as shown in Figure 7-13.