IAD SERIES USERS MANUAL
82
management page; Select "disable" and "this user has
no access to the page" pops up.
Status
Select "enable", the user can normally use; Select
disable. This user is currently unavailable.
9.Product problem analysis
Why is the POWER indicator not on?
Answer: Check that the power adapter matches.
Please check whether the power connection is valid. Please check whether the power switch is on.
Why is the Ethernet (ETH) indicator not on?
Please check the network connection is correct or not.
Please check the network connection is reliable or not.
Why isn't the LAN indicator on the computer on?
Please check whether the type of cable from this product to the computer is correct.
Please check if the network connection is valid. Please check whether the computer network card indicator light is
on. Please check whether the network card works normally:
The way to do this is to look at the device name under "network adapter" in Windows device manager. Whether
with “?” Or "!" Symbols. If yes, please reinstall the device after deleting it, or change the network card to a new
slot. If the problem persists, please replace the network card.
How to restore factory default Settings?
The steps to restore the factory default configuration are as follows:
Find the "RESET" button in the front panel of this product. Press the "RESET" button with the needle and hold it
for more than 3 seconds, then release it.
Further Inquiry ?
During the use process,if you meet any configuration and using problem of the product,please dial to the customer
service 0757-82288116 email to
for information.
In the contact process, you need to provide the equipment identification
(the equipment identification can be obtained on the bottom label of the
product, in the form of "XXXX XXXX XXXX").