UV KIT - INSTALLATION GUIDE
(BACK VIEW WITH CHILLER, UV, AND FILTER)
INLET
OUTLET
UV
FILLER DELIVERY
TUBE
INLET
OUTLET
SOLENOID VAVLE
FIG. 9
(BACK VIEW)
FIG. 10
SEE FIG. 11
FOR DETAILS
UV HOUSING
QUARTZ SLEEVE
AND O-RING
RETAINER NUT
UV LAMP
POWER SUPPLY
AND CONNECTOR
FIG. 11
1/4" X 3/8"
REDUCER
3/8" X 1/2"
REDUCER
1/2" X 1/2"
ELBOW
REMOVE LOWER AND UPPER FRONT PANELS, IF NEEDED
SCREW UV HOUSING CLIP TO FRAME (ONLY ONE CLIP
REQUIRED). HOLES PROVIDED IN FRAME UPPER LEFT
SIDE (BACK VIEW).
INSTALL INTER CONNECTING WATER FITTING TO UV
HOUSING, PROVIDED. REFER TO FIG. 10 AND 11 FOR
DETAILS.
INSTALL QUARTZ SLEEVE WITH O-RING INTO UV
HOUSING. ASSEMBLE RETAINER NUT - DO NOT OVER
TIGHTEN REFER TO FIG. 10 FOR DETAILS.
RUN UV POWER CORD CONNECTION THROUGH HOLE
PROVIDED IN FRAME. CONNECT UV BULB TO POWER
SUPPLY CORD AND INSERT BULB INTO UV HOUSING. SEE
FIG.9 AND 10 FOR DETAILS.
HOLE PROVIDED
FOR ELECTRICAL
AND WATER RUN
STEP 9
STEP 10
CAUTION --- CAREFULLY SNAP UV HOUSING INTO CLIP
INSTALLED IN STEP 9. THE UV BULB AND QUARTZ SLEEVE
ARE MADE OF GLASS AND ARE FRAGILE. USE CAUTION IN
THIS STEP TO AVOID DAMAGING THESE PARTS.
CONNECT ALL INTERCONNECTING WATER LINES. SEE
WATER CIRCUIT ILLUSTRATION ON THE NEXT PAGE.
RE-CONNECT ELECTRICAL POWER AND INSTALL UPPER
AND LOWER FRONT PANELS.
A
C
B
D
E
C
B
A
