MagniLink Vision TTS
24
User Manual 7944787b | MagniLink Vision TTS
6.6
Extra voices on a USB stick
It can be possible to use voices that are on an external USB drive. To
enable the voices, connect the USB stick to one of the unit’s USB ports
and wait until the unit says “voices are ready to be used”. It is then
possible to go into the menu and change voices and language settings
to one of the new voices.
6.7
Quality of OCR conversion
In order to optimize the results of the OCR conversion, you should bear
in mind the following.
Make sure that the text is large enough. If the text is too small, the
OCR results will be bad. At least 12pt is recommended.
Avoid glossy paper as this results in reflections in the image. This
impairs the results of the OCR conversion. If you intend to use
glossy paper, we recommend that the light on the unit is switched
off.
Certain fonts can be difficult for the OCR engine to interpret.
It is important that the text contrast is sufficient.
It is important that the chosen spoken language is the same as that
of the text.
The paper should be rotated as little as possible.
