MagniLink Zip
User Manual 7943529c | MagniLink Zip
11
6
Installation
Open your MagniLink Zip
1.
Place your MagniLink Zip far enough in on the table in front of your seat, but at
least 10 cm from the edge of the table. Remember that the reading table can be
pulled out approximately 30 cm in three directions. MagniLink Zip has a low total
weight. Therefore, it is very important to place the system in the right place on
your table, particularly when you are using the reading table in its most extended
position. Excessive load in this position can cause the system to tip over.
2.
Take hold of the unit's arm and turn it upwards until you hear it click into place.
3.
Turn the screen up to the desired position. When you do this, the camera will
automatically move into the right position.
Install the battery (if your MagniLink Zip was supplied with a battery)
4.
Turn the unit's arm so that it is easy to access the battery compartment. Place the
battery in the contact on the top of the battery compartment.
5.
Press the battery cover in place in the unit.
Connect the power cable.
6.
Connect the mains adapter to the rear of the unit and to the wall socket. The unit
is now ready to be used.
