LX Navigation d.o.o. LX 7007 C May. 30th 2012
- 16 -
•
SC: VOL H audio volume will be increased or decreased during speed command period set (H) or ( L)
•
0%:
tone frequency at 0 m/s
•
+100%:
tone frequency at full + deflection
•
-100%:
tone frequency at full – deflection
2.3.2.4
Audio Alarm
The unit produces an audio alarm on reaching certain confirmation points.
This screen allows the parameters of the audio to be configured. Also
Entering airspace will be accompanied with an audio warning.
Setting in this menu makes it possible to customize the audio tone.
2.3.2.5
Turn points
This section is about some settings relating to turn points and
TP file management. The unit accepts
.CUP
file format
And the store capacity is almost unlimited.
Input of TP files is exclusively via SD card.
Near rad.:
defines radius around the turn point which will be taken as a confirmed turn point after flying
of a so called simple task
A Simple task is flying without specifying a task around turn points and APTs. All TPs or APTs
detected as inside (Near rad.) will be taken as part of a task. (Not active at the moment)
Sort:
defining TP sort criteria, alphabet and distance are offered
Task file:
the unit is capable of managing up to three turn point files at the same time, combining the points
of all three files. If a turn point file activated as
Task file
includes also task data, those tasks will
be available for navigation (maximal 20) and selectable from imported task store.
The turn point files stored under File will not contribute task data.
File:
only the turn points in the specified file will be available for navigation and user task creation
QP name:
turn points names which are a result of saving the ‘actual position can be designated under
a pilot’s individual requirements. Such a turn point name consists of two characters and time.
QP date:
if enabled all actual position names will be stored under date and time
QP auto sel.:
if ON is set, the turn point will become active immediately after saving the ‘actual position
’
is done, otherwise a normal select procedure will be required
Note!
If a Voice Module option is used, the alarms will be
disabled
automatically to prevent double warnings.
