LX Flarm Red Box V4.04
LX Navigation d.o.o.
Feb.2009
4
2.1 Part list
2.1.1 Flarm Red Box
•
Flarm red Box unit
•
RF antenna
•
GPS antenna
•
Flarm External display with cable (1x 60cm and 1x 150cm)
2.1.2 Flarm interface for LX 5000
•
Flarm Interface for LX 5000 unit
•
RF antenna
•
GPS antenna
•
Flarm External display with cable (1x 60cm and 1x 150cm)
3 Operation
The unit will run immediately after power will be applied. With GPS antenna connected and visible satellites about three
minutes will take to be operable. There are no commands or status indicators on the unit. All important statuses are be
readable on External display, also all inputs will be done this way.
3.1 Flarm external display
The unit consists of a 50x20 mm flat housing which has one push button and 16 LED’s. A 6P telephone type connector
connects External display with Flarm unit. Each LED position is equipped with two LEDs, one red and one green.
•
10 radial positioned LED’s, defines direction to the near glider (top LED active means frontal collision risk)
•
2 additionally red light emitting diodes marked like above and below informs about vertical position of the
glider, which is close.
•
Mode button is used to control the unit, see table below
•
5 status LED’s.
Status LED
Warning/Nearest LED
Mode selector
