LX Traffic Square
Device setup
Document name:
LX_SQUM
Document revision:
R1
5.2.4.1
Turnpoints
Turnpoint files, in the .cup file format, are not supplied by LX navigation, but can usually be
found at competitions, various webpages or from club manager and club mates. As a starting
point, you can check the
. You can even create your own turnpoint files
either by hand, or using different software.
In order to use turnpoint files on your LX Traffic Square, first you need to copy them to the
device. In order to do this, you need to have the file saved to the
root of your microSD
card
. Once the microSD card is inserted go to
Load
sub-menu and select the file you wish to
transfer to the LX Traffic Square’s internal memory.
Now go to the
Select
sub-menu and select which of the files in the LX Traffic Square’s internal
memory you wish to have active.
You can have multiple turnpoint files active at the same time.
NOTE
The LX Traffic Square requires turnpoints in the .cup file format.
5.2.4.2
Airports
Airport files, in the .af file format, are supplied by LX navigation exclusively. For the latest
available database files, check the
The airports file holds the frequencies to all airports, which is why it is especially important to
use the latest database files available. If inconsistencies are found in the files, please refer
them to the
In order to use a certain airport file, first you need to copy it to the LX Traffic Square’s
internal memory, through the
Load
sub-menu, and then select it as active through the
Select
sub-menu. Only one airports file can be active at a time.
NOTE
The LX Traffic Square requires airport files in the .af file format.
Device manual
Public
31
