Power Button Functions
13
E-EQ-MX1ISOGWW-J
MX1 I-Safe User’s Guide
Power Button Functions
Figure 12 Location of the Power (PWR) Button
Note:
The IR window and four battery charger connectors are present, but they are non-
powered and non-functional. The unit does not have a backup battery.
The Power button is used to turn the MX1-IS on and off and force it into the Suspend state. The
button will beep when pressed and beep again every second while it is held down.
How To
•
Turn the MX1-IS off
Hold the Power key down for 4 beeps (signifies 3 or more
seconds) then release.
•
Turn the MX1-IS on
Hold the Power key down until the display turns on.
•
Force the Suspend state
Tap the Power key (1 beep). The Suspend state is useful for
breaks or brief periods when the unit will not be used.
•
Wake from Suspend
Tap the Power key to wake the MX1-IS from Suspend
(before the 5 minute timer expires).
Off Timer and Critical Suspend Mode
The MX1-IS is automatically turned off when the Off Timer expires. The Off Timer runs when the
MX1-IS is in Critical Suspend mode. The MX1-IS automatically goes into Critical Suspend when
the Main Battery is reaching the critical power mark. The Off Timer default is 5 minutes. The
value can be adjusted using the BIOS Setup.
Important:
The MX1-IS Main Battery must be replaced when the unit enters Critical Suspend.
Turn the unit off before replacing the Main Battery.
