E-EQ-MX1ISOGWW-J
MX1 I-Safe User’s Guide
Operation
Insert I-Safe Main Battery Pack
Important:
Do not place MULTI-chargers in hazardous locations.
Note:
New batteries must be charged prior to first use
. This process takes approximately three
hours in an LXE I-Safe MULTI-charger.
Note:
The MX1-IS battery pack can be exchanged with a fully charged battery pack in a
hazardous location. The MX1-IS must be turned off before the Battery Door is opened.
Figure 14 Open Battery Door
The MX1-IS Battery Compartment is located on the lower rear of the computer. Unfasten the
protective leather cover. Open the Battery Compartment door by pressing down on the door latch
slide tab at the top of the compartment. Remove the battery door.
There is no need to remove the pistol grip handle or the protective leather cover.
Care should be used when inserting or removing the battery pack so that damage does not occur to
the battery contacts on the MX1-IS. If damage does occur, cease using the unit until inspection or
repair can be performed by a qualified technician.
The Main Battery Pack should be inserted tab end first so that the tab mates with the hole at the
top of the battery compartment. The battery will then lay inside the battery compartment but will
not be secure. To secure the battery, the battery compartment door must be in place and the door
latch locked. This provides the tension necessary to hold the battery pack in place.
Note:
There is no backup battery in the MX1-IS device.
