HHP Properties
Option
Action
In
Aggressive Linear Decode mode
the imager will only read linear symbologies in this mode, but decoding these
is faster and more accurate than Standard Mode.
In
Quick Omni mode
the imager searches for a barcode in a reduced field located around the center of the image.
Decoding is faster in this mode, but the user must center the aiming line over the barcode to be read. Both linear
and 2-D symbologies can be read in this mode.
The default is Standard.
Range
Set the linear range.
Valid:1 – 6
Default:3
A value of 1 specifies that the linear range that is searched for a readable label is a tight vertical range near the
aimer. A value of 6 specifies that the entire height of the image is to be searched.
AIM
Duration of the imager aim beam in 0.1 second increments.
Valid:0 – 50 (0 to 5 seconds)
Default:0
Lights
Specifies if the imager's lights and aimer should be left on during the entire decode process.
The default is disabled.
If disabled, the lights are turned on only during image capture, then turned off while the imager attempts to
process and decode the barcode.
If enabled, the aimer and lights remain turned on during the entire process.
In Aggressive Linear Decode mode, set this parameter to enabled to improve the aimer visibility. See “Mode”
above.
E-EQ-MX8WMRG-C [ 130 ] MX8WM Reference Guide
