Installation Procedure, LXE Models 6723 Bridge & 6720 AP (RoHS)
195
E-EQ-NEMARG-F
NEMA Type 4 Enclosure Reference Guide
159128-0001-R Rev. A
Page 5 of 11
10. Plug the output power cord from the Power Bricks into the Power Injectors.
Route cable as shown in figure 5.
11. Position the AC Power Brick over the Foam Pads with the label side (bottom)
up and the AC input pointing towards the bottom of the box. See figure 6.
12. Position the Power Injector over the Foam Pad on Bracket 160042-0001 up
against the locating tabs with the RJ45 jacks pointed towards the top of the
box. See figure 6.
13. Place Brackets 160043-0001-R and 160046-0001-R over the Power Brick and
Injector. See figure 6.
Figure 6
Network
RJ45 Conn.
AC power
connector
Cable Tie Down
Installed Here
BOTTOM
Figure 5
