Installation Procedure, LXE Models 6453 Bridge & 6540 AP (non-RoHS)
59
E-EQ-NEMARG-F
NEMA Type 4 Enclosure Reference Guide
159086-0001 Rev. B
Page 9 of 10
27. Insert the antenna cable connectors in the holes and secure them.
28. Plug the antenna cables into the AP.
29. Route and connect the Crossover cable between the AP and the Bridge.
30. Secure the crossover cable and the AP antenna cables to the AP bracket. See
figure 12. Loop the cable tie between the bracket and the AP. Pull it tight and
trim.
31. Obtain two (2) female power cords (Supplied Locally).
32. Plug a cord into each power transformer and route it to the terminal block.
33. Cut the cords and remove at least 2” inches of the outer covering from the cut
end of the cord. See figure 13.
Figure 12
Cable tie
goes here.
