80
Installation Procedure, LXE Model 6730 AP (non-RoHS)
NEMA Type 4 Enclosure Reference Guide
E-EQ-NEMARG-F
159088-0001 Rev. C
Page 12 of 14
30. Bundle the excess cord as shown and tie it down with an 8” nylon tie to the tie
down near the power brick. See figure 16.
31. Trim the nylon tie after pulling it tight.
32. Obtain the power cord supplied with the AP.
33. Measure 21” from the universal plug end of the AC power cord (supplied with
the AP) and cut. Discard the remainder of the cord.
34. Remove at least 2” inches of the outer covering from the cut end of the cord.
See figure 17.
35. Remove 0.4” (10 mm) of the insulation from each conductor.
36. Plug the power cord into the power supply brick
Figure 16a
Figure 16b
Figure 17
2”
