LXNAV CAN Remote Installation Manual Version 1.1
April 2018
Page
6 of 9
4
Installation
LXNAV remote stick is connected to CAN bus through Remote-Can adapter.
Be careful, that connect correct colour wire to pin, which is marked with same
colour.
PTT wires are connected to radio, SC is connected to Speed to fly input of vario unit.
Remote stick will not operate, until is registered on device. Remote stick can be
registered under setup-hardware-Remote stick. Registration must be done on each
unit (S80 and S80D)
Can bus is under power supply at all times, consequently remote stick is also under
power. After flight, please disconnect batteries or switch off master, to prevent
discharging batteries.
