F display Version 1.21
December 2018
Page 17 of 26
5.4
Setting up F
If we touch LXNAV F with two fingers for 6 seconds, LXNAV F will go into
setup mode, where following settings can be adjusted:
•
Brightness of LED’s
•
Units setting
•
Vertical indicator resolution
•
Decimal point
•
Near mode
•
PCAS setting
•
Volume on beeper
Same long touch with two fingers will exit from setup mode.
Setup mode is indicated with following horizontal indicator image:
With long touch (1 second) to the touch pad we are switching between different settings,
which can be set.
Short touch will change value for actual setting.
First (left digit) indicates the setting, that we are setting, second digit (right) shows the value
of that setting.
On picture below, left digit indicates character “b”, right indicates character “A”.
