LX90xx system Version 4.0
February 2014
Page 119 of 151
Delta time
is the difference between the remaining time and time of arrival. If it is
negative you will arrive back home too soon and if it is positive you will arrive too late.
Keep in mind that the time of arrival can be calculated using different methods which are
found in the QNH and RES setup (see Chapter 6.1.1).
A point is moved using the lower two knobs.
Press the
DIS/BRG
or
LON/LAT
button to toggle between the two methods of moving the
point.
When the
DIS/BRG
button is shown the point is moved in the x, y directions. Use the
PAGE selector knob to move the point in the north/south direction or rotate the ZOOM
selector knob to move point in east/west direction.
If the
LON/LAT
button is shown the point is moved in the radial and azimuth directions.
Radial direction is indicated with red line going through whole sector. Rotate the PAGE
selector knob (page selector) to move the point in the radial direction from the area centre.
Use the ZOOM selector knob (zoom) to move the point in the axial direction.
If more than one assigned area is set for a task the
NEXT>>
button is shown in the lower
line. Press this button if you wish to move the point into another assigned area.
Summary of Contents for LX90xx
Page 2: ......
Page 129: ...LX90xx system Version 4 0 February 2014 Page 129 of 151 ...