Rev #5
Version 1.01
July
2020
Page 18 of
34
4.8.3.5.4
Zone
Edit the turnpoint zo
ne. Following options are awailible to edit:
•
Direction:
Options include Start, Previous, Next, Symmetrical or
Fixed angle.
•
Angle 12
: is
greyed out unless fixed angle is specified in Direction.
•
Line Check Box
; typically used for Start and Finish. If line is checked then
Angle 1, Angle 2 and Radius 2 are greyed out.
•
Angle 1
: Sets the angle of the Turn Point Zone.
•
Radius 1
: Sets the radius of the Turn Point Zone.
•
Angle 2
: Sets angle 2 for complex Turn Points and Assigned Area Tasks.
•
Radius 2
: Sets the radius for complex Turn Points and Assigned Area Tasks.
•
Auto Next
: Typically used in racing tasks, this will change the navigation of
the TrafficView
to the next turn point when a single fix is made within the Turn
Point Zone.
4.8.3.6
Sounds
Adjust the sound levels. This menu is the same as the one found in Setup->Hardware-
>Traffic sounds.
4.8.3.7
Night
Once night mode is activated the instrument screen will go darker to adjust for low ambient
light in night conditions. Clicking night mode again will return to normal mode.
4.8.3.8
Cancel
Close the manu and return to the previous screen.
Inside,
you can quickly edit target (callsign, pilot, ai
rcraft type, registration…), adjust sound
levels, and switch brightness to night mode.
4.9
Flarm Warning
If Flarm warnings are enabled, (the following is) a typical screen display is as follows. The
first (Classic view) is for normal Flarm warnings, the second one is for undirected/PCAS
warnings, the third one is for obstacle warnings.
The screen indicates the relative position of the threat. In the first image, one glider is
approaching from right side (two o’clock) and from
120m above
.
