Rev #5
Version 1.01
July
2020
Page
21
of
34
The Classic Layout uses a classic Flarm watch warning.
The TCAS layout looks like a classic TCAS displays.
Active timeout
adjusts the remaining time for a glider on the map after last seen.
Inactive timeout
adjusts the remaining time of inactive gliders on the list. Inactive gliders
are gliders, (which) whose signal was lost. After Active timeout, they became inactive and
remain(s) only on the list.
The line to
selected target and selected waypoint
can be enabled or disabled in this
menu.
If the glider vertical distance is less than 100m (330ft), then this glider will be painted with
near glider colour
. Gliders with vertical distances above that, will be painted with
above
setting, and
below
100m (330ft), they will be painted with below setting.
Zoom mode
can be set to automatic (zoom to the target), or manual.
If Target
label text
is selected, a near glider will display a chosen value.
Lock on nearest
automatically selects the nearest target, and displays its data. In case,
(that) you want to select another target, it’(s) is possible. After 10 seconds, TrafficView will
automatically switch back to the nearest target.
If no target is selected,
Auto select
will select to any new incoming target.
Lock on
nearest
has a higher priority.
If
Draw history
is enabled, paths of the Flarm objects will be seen on the screen for the
last 60 points.
The
size
of the
plane
and
Flarm objects
can be adjusted.
4.11.2.2
Airspace
In airspace setup, a user can globally enable
showing airspace,
do some adjustment to
filter
airspace below selected altitude, define
colour
of each type of the airspace zone.
