Rev #5
Version 1.01
July
2020
Page
22
of
34
4.11.2.3
Waypoints
In waypoints setup, a user can globally enable
showing waypoints,
limit the
maximum
number of visible waypoints,
and set the
zoom level
up (to which we) the one that will
display the
name
of the waypoint.
Draw line
to waypoint can be enabled in this menu as
well.
4.11.2.4
Theme
Dark and Light themes are available and can be switched here.
4.11.2.5
Modes
If (we) you want to skip some modes from the main screen, (we) you can do that in this
setup menu.
At the moment, only task and waypoint modes can be hidden.
4.11.3
Warnings
In this menu, (we) one can manage (with) all warnings. (We) One can globally
enable
or
disable
all warnings. And enable individually
urgent, important
and
low-level alarms
.
Beware that, if you disable warnings globally, you (wont) will not see them (nor hear
alarms), even if individual warnings are enabled.
Dismiss time
is a time in seconds, when the same warning (will) appears again after
dismissing it.
If (we) you do(n't) not want any Flarm warnings immediately after take-off, (we) you can
check
no warnings for first 3 minutes
.
The warnings are classified into three levels:
•
First level (Low
) approximately 18 seconds before predicted collisio
n.
•
Second level (
Important) approximately 13 sec
onds before predicted collision.
•
Third lev
el (Urgent) approximately 8 seconds before predicted collision.
4.11.4
Obs. Zones
This menu is for setting start, finish and waypoint sectors, their shapes and other properties.
4.11.5
Hardware
4.11.5.1
Communication
(Only) Communication speed can be set only in this menu. The default setting for all Flarm
units is 19200bps. The value can be set between 4800bps and 115200bps.
It is
recommended to use the highest bound rate supported by your FLARM device.
4.11.5.2
Traffic sounds
In the Sounds setup menu, one can set the volume and the alarms settings for the LXNAV
TrafficView.
•
Volume
The sounds slider changes the alarm volume.
•
Beep on traffic,
TrafficView will notify with a short beep (a), the presence of a new
Flarm object.
•
Beep on low alarm
TrafficView will beep on a low level alarms triggered by Flarm.
•
Beep on important alarm
TrafficView will beep on an important level alarms
triggered by Flarm.
•
Beep on urgent alarm
TrafficView will beep on a critical level alarms (collision)
triggered by Flarm.
