Once you have the slide positioned correctly, and the sight pusher block
set to the correct height, thread on the two hold down knobs and hand
tighten. DO NOT OVERTIGHTEN KNOBS!!
Recheck the slide and pusher block alignment. Once you are satisfied
with your settings start to rotate the Adjustment Handle so that the
pusher block moves in the direction you want the sight to move.
Some sights can be stuck or require extra force in order to get the sight
to move. If at any time the sight pusher block dramatically twists, STOP
FURTHER ADJUSTMENT.
If the pusher block is not vertical, you may have to tap the bottom cor-
ner of the pusher block with a punch and hammer in the direction the
sight is being moved.
DO NOT apply excessive force to the Adjustment Handle this may cause
damage to the AccuSight Tool or your sights.
Once you have the sight moving, you can utilize the hash marks located
on the front of the Top Carriage Assembly as a guide. Each hashmark
represents 1/32”.
Section II
1911 Type pistols
When installing sights onto 1911 type pistols or any other pistol that
has a slide profile like a 1911, you will want to use the notched area of
the Height Adjustment Clamp. The notch will fit the contour of your
1911 slide.
When installing front sights on a 1911 type pistol you want to use the
cut-out portion of the Bottom Assembly Block. Shown here.
5
