1 6
Firmware
Lyngdorf Audio supplies a free PC tool for upgrading the fi rmware of the CD-1. The latest revision of the
tool as well as the fi rmware can be downloaded from www.Lyngdorf.com.
Connectors
Mains Connector
Mains voltage to the CD-1 is applied via an IEC320 type connector. The supplied cable with safety ground
should be used to connect the CD-1 to a mains outlet.
Connect the power input only to the AC source printed on the label and the set-
ting shown on the voltage selector switch. The warranty will not cover any damage
caused by connecting to the wrong type of AC mains.
Always check the correct voltage 115V or 230V operation has been selected for the
voltage in your location or country. Failure to do this may result in serious damage
to your CD-1 component.
Always disconnect the CD-1 from the mains before changing any connections to its
inputs or outputs.
Analog outputs
The unbalanced RCA outputs are wired in accordance with normal practice:
Shell: Chassis and ground.
Pin: Hot (+).
Unbalanced analog output impedance 75 Ohm
The balanced XLR outputs are wired in accordance with IEC268:
Pin 1: Chassis and ground.
Pin 2: Hot (+).
Pin 3: Cold (-).
Shell: Chassis and ground.
Balanced analog output impedance 100 Ohm
Digital outputs
RCA output (SPDIF):
Shell: Chassis and Ground
Pin: Hot (+)
XLR output (AES):
Pin 1: Chassis and Ground
Pin 2: Hot (+)
Pin 3: Cold (-)
Shell: Chassis and Ground
Toslink
Summary of Contents for CD-1
Page 1: ...Owner s manual CD 1 Compact Disc Player ...
Page 2: ...2 ...
Page 20: ...20 www lyngdorf com ...
