- 6 -
Accessories
You should find the following in the accessory kit:
1. One mains cord
2. This manual
3. Remote control
4. Programming cable (RS232 Cable for firmware upgrade from a PC)
Operating voltage
The Millennium is available in a version for 115V mains voltage and in a version for 230V
mains voltage.
Check the label on the Millennium rear panel and verify you have the version with the
proper voltage for your geographical area.
The 115V version requires a mains voltage of 100V-120V at 50-60Hz with a current rating
of 8A.
The 230V version requires a mains voltage of 200V-240V at 50-60Hz with a current rating
of 4A.
The mains voltage setting for your Millennium can be changed
ONLY BY A QUALIFIED
ENGINEER
.
Connect the power input only to the AC source printed on the label. The
warranty will not cover any damage caused by connecting to the wrong
type of AC mains.
The Millennium has three power modes:
1.
OFF
– No circuitry is powered.
2.
STANDBY
– The mains transformer and amplifier section is powered off, only the
remote control input and the microprocessor is powered, so the unit can be
powered up using the remote control “STANDBY” button
3.
ON
– All circuits active
Product Registration
Please record the serial number of your amplifier here for future reference. The serial
number is printed on the label on the Millennium rear panel. You will need this serial
number, should you ever require service for your Millennium power amplifier.
Millennium MkIV serial number: _____________________
