Turn screws
until just snug
Set assembled base back on glide
frame with mounting holes on base
and glide frame aligned.
Attach base with dividers to glide frame
using mounting screws.
Only gently tighten.
Attach Dividers
7
•The use of a power screwdriver
•Drill 4 starter holes using a 1/8”
diameter drill bit.
Recommended:
Move glide
rails forward
Base
mounting
hole
2”
min.
50.8mm
2”
min.
50.8mm
2”
min.
50.8mm
Install front
screws first
Remove assembled base from glide frame.
Move inner glide rails slightly forward as shown.
Mount glide frame into cabinet using
wood screws found in parts bag.
Mounting Glide Frame
6
Check for adequate
cabinet & door clearance.
Adjust glide frame
position if needed.
Set the assembled base with dividers on
glide frame with mounting holes on base
and glide frame aligned.
Checking Cabinet Clearance
5
2”
min.
50.8mm
2”
min.
50.8mm
2”
min.
50.8mm
Make sure arrows
are pointing to the
front of the cabinet
Align glide frame in cabinet as shown using
alignment guide found in parts bag.
Aligning Glide Frame
4
Alignment Guide
© 2016 Lynk, Inc. 8241 Melrose Dr. Lenexa, KS 66214
LIMITED WARRANTY AND DISCLAIMER OF LIABILITY
The manufacturer warrants this product against defects in manufacturing and workmanship for a period of ninety (90) days from the date of purchase. For questions, call
(800) 733-5965 for customer service.
MANUFACTURER DISCLAIMS ALL OTHER WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR
A PARTICULAR PURPOSE WITH REGARD TO THE PRODUCT. IN NO EVENT SHALL MANUFACTURER BE LIABLE FOR ANY SPECIAL, INCIDENTAL, INDIRECT, OR CONSEQUENTIAL DAMAGES
WHATSOEVER (INCLUDING, WITHOUT LIMITATION, DAMAGES FOR LOSS OF BUSINESS PROFITS, INJURY TO PERSON OR PROPERTY, OR ANY OTHER INCIDENTAL, CONSEQUENTIAL OR
PECUNIARY LOSS), OR FOR ATTORNEY’S FEES OR COSTS, ARISING OUT OF THE USE OR OPERATION OF THE PRODUCT.
If you have questions, please call 800-733-5965
430321 Roll Out Cookware Organizer
R6
www.lynkinc.com
2
