Lynx CardModule D VD 5000, Reference Manual

Reference Manual D VD 5010 Version 1.0

Page 11  

Installation 

Caution 

The CardModule is shipped in a 

protective anti-static bag. Please take 
suitable precautions to avoid static 

discharge onto any part of the PCB or 

components when handling module or 
serious damage could result. 

Each Card Module is supplied with a rear 
connection panel and two mounting screws. 

Please follow the following procedure for 

installation of the card module into the Series 5000 
Card Frame. 

a)

Select a slot in the card frame where the 
CardModule will be located 

b)

Remove the blank connection panel from the 

rear of the rack (if fitted) 

c)

Install the rear connection panel using the 

screws supplied. Do not tighten the screws fully 

d)

Slide the card module into the card frame and 
carefully check the CardModule easily 

connects to the rear connection plate. The 
card should fit easily and should not require 

excessive force to insert, if you feel any 

resistance, there could be something wrong 
with the rear connection panel location. Do not 

try and force the connection. Remove the rear 

connection panel and check alignment with 
the CardModule. 

e)

Insert and remove the CardModule a few times 

to ensure correct alignment and then tighten 
the two screws to secure the rear connection 

plate