36
DSX
4.11.- Dynamics configuration.
The last section that we find on the Main window is the audio
Dynamics
, which consists of a block of
RMS
Dynamics
and followed for another block of
Peak
limiter. Once the signal reaches this point there will be
some parameters already applied, has Route selection, Gain, Crossover, Equalization and delay. All that
remains is a dynamic control (compressor - limiter).
Each output provides a sophisticated
RMS
compressor-limiter followed by a
Peak
limiter. The
limiters and compressors are
C.R.I.
type (Continuous Ratio Increment) with a low distortion.
First we use a RMS Detector to get high quality compression. The system will reach the maximum
power in a gradual delivered way, so then the sound will be perfectly clear and crisp at all times, avoiding the
typical problems of normal limiting.
Then we will have the Peak limiter with which you can control the maximum in mechanical displacement
of the loudspeakers. To adjust limiters, you can introduce gain amplifier, the maximum power and impedance
of the speakers connected to the output.
It also has a noise gate that will respond with the times set by the RMS dynamic and where you can
select different thresholds to eliminate noise.
In this way we will have a final control of the dynamics and you can limit the power delivered at each
output preciselly. Also, you can use the noise gate. To access this part, press over the icons of
RMS
(Dynamics
RMS) or
PEAK
(peak limiter):
Pressing the RMS button, the next window will appear from where you can modify the parameters of the
outputs dynamics:
Channel
selector
Type of dynamic
Dynamic
Graphics
Power
delivered
Speaker and
amplifiers Data
4 - EDITING WITH DSX
Summary of Contents for DSX-1004
Page 1: ...Valencia Spain www lynxproaudio com USER MANUAL V 11 08 DSX ...
Page 61: ......
