Lynx L400PS, Care & Use/Installation Manual

8

|

SEDONA CARE & USE/INSTALLATION

BEFORE EACH USE 

Before any use, always make sure that:
• ... you do not smell gas before you light the grill. If you 

do smell gas, shut everything off and have a qualified 
plumber check for leaks.

• … the cooking area is free and clear of any combustibles, 

besides your food, that might ignite. 

• … the control knobs turn freely.
• … if you are using a portable propane cylinder, it is se-

curely connected and leak tested. (See INDEX: “Cylinder 
Retention Requirements” for details.)

• … you know where the main gas supply shut-off is located.
• … the burners are seated properly in the grill with mount-

ing legs in the slots. The main burners must sit level and 
firmly on the burner support frames. (See INDEX: “Un-
packing and Assembly” for details.)

• … wind is not blowing too strongly or blowing on the 

back of grill.

PRE-GRILL CHECKLIST... 

continued

LIGHTING YOUR GRILL

ELECTRIC IGNITION

Before proceeding, make sure you have completed the 
“Before Each Use” checklist. 

Follow these steps to light any of the burners on your grill:

First, make sure all burner control knobs 
are set to OFF.

Test the ignition system by pressing the 
control knob in and listening for a click-
ing sound of the igniters. If no clicking 
sound occurs, proceed to TROUBLE SHOOTING or MANU-
AL LIGHTING sections. 

For the Main or ProSear™ Burner:

Push and hold the control knob in and rotate the knob to 
“LITE”. After ignition, set the knob to the desired heat setting.

If the burners do not light with in 5 seconds, turn the knob 
to OFF and wait 5 minutes for gas to dissipate, and repeat 
the step above.

For the Optional Rotisserie Burner

The rotisserie burner features a thermocouple sensor with 
a safety valve that automatically shuts off the flow of gas if 
the burner goes out. (See INDEX: “Windy Conditions” for 
tips on how to prevent burner blow out) 

To light the rotisserie burner, push and hold the control 
knob in for 2 seconds and then turn the knob to the “LITE” 
position.

After ignition CONTINUE HOLDING THE CONTROL 
KNOB IN for 30 to 60 seconds. During this time the 
thermocouple will heat up and the safety valve will remain 
open.

If you release the control knob before the thermocouple 
has heated up, the safety valve will shut off the flow of gas 
to the rotisserie burner and you will have to re-light the 
burner. 

            WARNING

1.  Never attempt to light a burner if you smell gas.

2.  Always keep the lid open (side-burner lids must be completely removed) when lighting your grill.
3.  Releasing fuel into a closed grill before lighting will increase the risk of explosion, property damage , personal 

injury or death.

4.  Keep your face and body as far from the grill as possible when lighting. Any time a burner doesn’t light within 

5 seconds, turn off the control, wait 5 minutes for gas to dissipate, and repeat the lighting procedure.

5.  YOU NEVER LEAVE THE GRILL UNATTENDED WHILE COOKING.