Lynx
Model
No.
LHFS
Page
11
P/N
33348
Rev.
A
7/2010
b
*
a
Push Down Handle to Open Door
Base Cover
Base Body
Installation Instructions
Assembly of Outdoor Patio Heater
1.
Disassemble shipped parts:
a.
Remove the Base Cover from the Base Body by unscrewing the eight (8) screws holding
the Base Cover on.
b.
Open the Door of the Base Body by pushing down on the handle to disengage the door
from the latch. Carefully cut the zip ties holding the Gas Hose Assembly to the interior of
the Base Body and remove the Burner.
*
Be Careful to “lift” out the Burner
to avoid
damage to the pilot assembly which extends from the cone shaped Inner Shield.
2.
Connect the Wheel Mounting Bracket to the base using two (2) screws and nuts attached. Insert the
screws through the Base of the Heater into the Wheel Mounting Bracket, so the nuts are visible.
As Shipped
Remove Shipped Parts
