Lynx
Model
No.
LHFS
Page
15
P/N
33348
Rev.
A
7/2010
Installation Instructions
8.
Insert the Outer Shield into the four (4) Shield Support Arms. Make sure to remove (peel off) the
plastic covering at before assembly.
9.
Remove one of the Fingers from Shield Support Arm then insert the Emitter Ring into the three (3)
Shield Support Arms (refer to figure A below), and re-assemble the Finger of last arm (refer to
figure B below). It is normal for the Emitter to have some movement for thermal expansion (once
the Reflector is assembled the Emitter will be held more tightly in-place).
Remove Finger from
Shield Support Arm
Figure -A-
Figure -B-
