Reference Manual P MX 3214 Version3.1
Page 17
Switch Settings
Below the switch setting for the two 8-position dip-
switches is defined. Please see the section following
the table for more detail on each switch function.
ONE DIP SWITCH IS PROVIDED FOR EACH EMBEDDER
Service Adapter
This module is complex by design. Configurations
are much easier with the R CT 3002 Service
Adapter. This provides a simple PC GUI for
configuration use. Settings can be quickly changed
and stored to the module flash ram. No local switch
settings are necessary. A single Service Adapter
can be used for all MiniModules.
SWITCH
Position
Set
Function
ON Local
Adjustment
Enabled
1
OFF Local Adjustment Disabled
ON
24 bit AES output
2
OFF 20 bit AES output
ON
Delete ALL incoming embedded AES audio
3
OFF ONLY replace Audio group selected with SW2
ON
No sample rate conversion performed
4
OFF Sample rate conversion selected (48KHz)
ON
Group 1 selected
5
OFF Group has to be deselected if other group
selected
ON
Group 2 selected
6
OFF Group has to be deselected if other group
selected
ON
Group 3 selected
7
OFF Group has to be deselected if other group
selected
ON
Group 4 selected
8
OFF Group has to be deselected if other group
selected
Summary of Contents for P MX 3214 B
