Reference Manual P MX 3214 Version3.1
Page 19
Dip Switch 3
Delete embedded audio
. When set to
ON
this will
delete
ALL
incoming AES audio signals on the input
SDI signal (if any). When set to
OFF
only the
channels selected for embedding (using SW2) will
be overwritten. Any remaining audio, which was
present on the incoming SDI signal will pass
transparently.
Dip Switch 4
Sample rate conversion ON/OFF
. This is used to
select sample rate conversion for the module. This
setting applies both input audio signals. When set
to
ON
(asynchronous) all incoming audio will be
sample rate converted to 48 KHz. (input range
30KHz to 48KHz). When set to
OFF
the sample rate
conversion will be bypassed. If bypassed, all
incoming audio must be synchronous to the input
SDI signal. This is useful if the module is to work with
Dolby audio data where the audio should not be
resampled.
Dip Switch 5 through 8
Select Audio Groups
. These four switches are used
to select which audio groups are to be embedded
into the incoming SDI video.
ON
selects the audio
group and
OFF
deselects it.
NOTE
: If two groups are selected at the
same time, embedding is switched off
Auto Store
If no parameters are changed for 10 seconds then
the current settings will be written into flash memory
automatically, this can be seen by the front LED
flashing yellow four times.
Summary of Contents for P MX 3214 B
