lynxspring.com
shop.lynxspring.com
1210 NE Windsor Drive
Lee’s Summit, MO 64086
sales@lynxspring.com
1 (877) 649-5969
© 2017 Lynxspring, Inc.
All Rights Reserved
Revised 2/21/2017
Page
8
of
16
Connecting by Cellular to Devices
The Cellular IP Address is located at the bottom of the D
EVICE
S
ETTINGS
screen. This IP address will be used to access the devices being
routed to on your network. Please note that UDP connections require
the Default Gateway of the device being connected to be set to the
Cellular Router’s internal IP Address.
Received Signal Strength
The cell signal strength is displayed in the page header as a bar graph.
Be sure to install the Onyxx-CE121 where you receive the best signal
level.
Figure 16
Port 80
The Cellular IP can also be used to access the web interface for this device if you have not assigned port 80 as a WAN
Port for a route. To do this you will use the Cellular Router Device IP address and the WAN port that was specified for
the device.
Cellular Router Device IP can be found on the D
EVICE
S
ETTINGS
page.
Figure 17
WAN Port numbers can be found on the Define Routes page
Figure 18: Example Route
The web interface can now be accessed by combining these two items by a colon.
Below is an example:
In our examples above
(figure 17 and figure 18)
you would enter into your web browser:
http://166.157.2258.21:4444