STAINLESS WAX MELTER WITH GAS STOVE
(LPG)
1. General safety instructions
Before first use read the manual carefully and follow the
instructions contained therein. The manufacturer is not
liable for damage caused by equipment used
inappropriately or by incorrect handling.
1.1. Operation safety
1.
The device is not intended for use by persons (including
children) with limited physical, sensory or mental abilities,
or by inexperienced users, unless under supervision or
with instructions given by an accountable party.
This device is not a toy, and shouldn’t be used as one.
Children should not to play with it.
2.
In the event of damage to the device, to avoid any health
and safety risks, repairs should be carried out only by
qualified personnel.
3.
Never carry out any maintenance or repairs during
operation or if the device is plugged in!
4. In the event of any danger, immediately disconnect the
gas cylinder and move away from the machine. The
melter may be restarted after the hazard has been
eliminated.
In the case of not following this instruction
and if the installation is carried out by an unqualified
person, there is a danger of damage to the device,
property, fire, explosion, suffocation or other injuries
that could result in permanent disability!
•
After completing the installation of the unit, check
the tightness of all connections using a leak
tester (electronic or soap).
•
Never use open flame to check for leaks!
2. Gas stove operation
(for
W4070)
2.1. Assembly
1. Legs
2. Leg fixing screws
3. Washers for leg fixing screws
4. Leg fixing gasket
5. Thermoelectric cable
6. Valve with thermoelectric safety device
7. Valve knob
8. Piezo igniter
9. Piezo igniter button
10. Ignition electrode
11. Air adjustment band
12. Screw to tighten the band
13. Connection stub
14. Valve control nut
15. Igniter and thermocouple wire fixing bracket
16. Igniter electrode and thermocouple wire fixing
screws
17. Igniter electrode and thermocouple wire fixing
nuts
18. cast iron burner
19. Mounting bracket for piezo igniter
20. Spigot for inspection
2
