MINI WAX EXTRACTOR
Prior to operating the device please refer to the manual and
act according to the guidelines contained therein. The
manufacturer cannot be held accountable for the damages
cause by misusing the device or its improper handling
1. GENERAL SAFETY OPERATIONAL
PRINCIPLES
1.1. ELECTRICAL SAFETY
a)
The device must be connected to the socket , having the
voltage specified on the product nominal plate.
b)
Electric installation must be equipped with RCD having
the nominal activation current below 30 mA. The
operation of the over-current circuit breaker must be
checked periodically .
c)
Regularly check the supply cable. If a non-detachable
power supply cable gets damaged, they must be
replaced. In order to avoid the threat, it must be
performed by a guarantor or by a specialised servicing
centre or by an authorised person. Do not operate the
device when a supply cable is damaged .
d)
d) In case of damage and in order to avoid the threat, the
repairs must be performed by a guarantor or by a
specialised servicing centre or by an authorised person.
e)
It is forbidden to pull the supply cable.
Power supply cable must be kept away from the heat sources,
sharp edges and its good technical state must be taken care of.
1.2. OPERATIONAL SAFETY
a)
The following equipment is not intended to be used by
persons with limited physical, sensory or mental
capabilities (including children) or persons inexperienced
or unfamiliar with that type of equipment unless the usage
occurs under supervision or in line with the equipment
operating manual provided by safety supervising persons.
b) The floor on which the device has been placed ought to
be dry!
c) The lid must be closed during operation!
d) Do not displace the device while in operation.
e) Protect the heating element against humidity (also during
the storage)
f) Do not operate the device in the vicinity of flammable
materials.
g) It is forbidden to make any maintenance works while
device is under operation.
h) The device may be activated indoors only. It has not been
adjusted to be operated outdoors.
WARNING !!!
While in operation, the device gets hot
excessively from the outside (external
jacket)
2. DEVICE CHARACTERISTICS
The device with water jacket is intended to melt the wax.
Proper design allows to heat the wax evenly along the entire
surface of the device.
2.1.
DEVICE DESCRIPTION
3 4 5 2 1
Description
:
1- wax discharge valve ½”
2- vent ¾” , maximum water level inside the heating
jacket, water refilling
3- heating element with temperature regulator
4- lid
5-
tank the wax
2.2. DEVICE TECHNICAL PARAMETERS
:
•
Insulated tank made of stainless and acid-resistance
steel plate
•
Heating element power supply – 230V
•
Heating element power – 2000W
•
Temperature regulation from 0 to 75ºC
•
Discharge valve 1/2”
(1)
•
Capacity 12 litres
•
Dimensions: l.*w.*h.
500*400*380mm.
