© 2016 Lytx, Inc. – Confidential & Proprietary
15
Attach the Bracket to the Windshield
Step 1: Make sure the glass is clean and dry and the air temperature is at least 50
F
(10
C).
Step 2: Remove the backing from the adhesive side of the bracket.
Step 3: Make sure the large plastic washer is on the left side of the bracket (see image
below or next page).
Step 4: Start by placing the top edge of the bracket against the windshield, aligned
with the marks, and make sure it is level.
Step 5: Press the bracket firmly against the windshield starting at the top and pressing
the sides downward.
CAUTION: Do not apply excessive pressure as it may cause the windshield to
break.
Step 6: Check from outside the vehicle to make sure there are no large air bubbles
under the bracket.
Note: You may need to (carefully) apply additional pressure to the bracket and
remove any large air bubbles. Use a small pin to create an escape path for the
air if the problem is persistent.
Step 7 : After 5 minutes of adherence, the event recorder can be attached to the base
of the bracket.
Step 8:
Secure the event recorder in the bracket using the two Torx screws and Torx
wrench (provided).
Mount the Event Recorder in the Bracket
CAUTION: The adhesive is very sticky. Once
applied to the windshield, it cannot easily be removed.
