3
0°C
°C
°C
-10°C
SAFETY TIPS
The device emits invisible (IR) and visible laser radiations. The visible
laser beams can be activated during the installation process to adjust
the position of the detection field.
Do not stare directly into the visible red beams.
The visible laser beams are inactive during normal functioning.
The door control unit and
the door cover profile
must be correctly earthed.
Test the good functioning
of the installation before
leaving the premises.
Only trained and qualified
personnel may install and
adjust the sensor.
•
The device cannot be used for purposes other than its intended use. All other uses cannot be guaranteed by the manufacturer of
the sensor.
•
The manufacturer of the door system is responsible for carrying out a risk assessment and installing the sensor and the door system in
compliance with applicable national and international regulations and standards on door safety.
•
The manufacturer of the sensor cannot be held responsible for incorrect installations or inappropriate adjustments of the sensor.
•
The warranty is void if unauthorized repairs are made or attempted by unauthorized personnel.
Avoid extreme
vibrations.
Do not cover the front
screens. Remove the
laser window protection
before use.
Avoid moving objects
and light sources in
the detection field.
Avoid the presence
of smoke and fog in
the detection field.
Avoid condensation.
When needed, wipe the
laser window only with
a soft, clean and damp
microfibre cloth
Avoid exposure to
sudden and extreme
temperature changes.
Avoid direct exposure
to high pressure
cleaning.
Do not use aggressive
products to clean
the front screen.
Keep the sensor
permanently powered
in environments where
the temperature can
drop below -10
°
C
.
CAUTION!
Use of controls, adjustments or performance of procedures other than those specified herein may result in
hazardous radiation exposure.
INSTALLATION AND MAINTENANCE
SYMBOLS
Caution!
Laser radiation
Remote control
sequence
Possible
remote control
adjustments
Factory values
Attention
Note
