MM-010539-001, Rev. P6G
40
To connect DATA cable to Client
1.
For Ethernet and Fiber Optic models, fabricate the cable as described in Section 11 or follow the
manufacturer’s instructions.
2.
Connect one end of the cable to the LAN or Fiber Optic network connection.
3.
Mate the other end of the DATA cable’s connector to the Client by visually aligning the key and
firmly push and turn the outer locking ring clockwise until it stops. A click will be sensed to confirm
proper mating.
4.
Ensure the dust cap is fully seated on the service port.
5.
For added protection against long-term exposure to weather, industry techniques for sealing the data
connection may optionally be performed.
CAUTION
Upon connection, verify that all cabling is not under any stress, a service loop is
maintained, and the cabling is restrained according industry techniques.