23
9 EQUIPMENT
REQUIRED
The equipment required for installing the M7100
IP
Series Mobile Radio is
listed below:
•
Crimping tool for fuse holder
•
Electric drill for drilling mounting holes
•
Drills and circle cutters, as follows:
o
No. 31 (1/8-inch) drill
o
No. 27 (9/64-inch) drill
o
5/8-inch drill or circle cutter
o
3/4-inch circle cutter, hole saw or socket punch
•
Phillips and flat-blade screwdrivers
•
POZIDRIV
®
driver
•
No. 20 TORX
®
driver
CAUTION
Be careful to avoid damaging some vital part (fuel tank,
transmission housing, etc.) of the vehicle when drilling
mounting holes. Always check to see how far the
mounting screws will extend below the mounting surface
before installing.
CAUTION
If pilot holes must be drilled, remove all metal shavings
from drilling holes before installing screws.
Summary of Contents for P5100 Series
