32
Figure 10-7: Control Unit Mounting Bracket Installation
10.2 CONTROL UNIT MOUNTING
(Remote Applications Only)
1. Using the bracket as a template, mark and drill the mounting holes. Be
sure to leave enough room at the rear of the control unit for the cable
connector and to allow the unit to swivel. Refer to Figure 10-7 for control
unit mounting bracket installation.
2. Secure the mounting bracket using the four No. 10 x 3/4 self-tapping
screws supplied (use No. 10 x 1-1/2 if needed.).
3. Secure the control unit to the bracket with the two ¼ - 20 x ½ hex head
screws and lock washers provided.
10.3 PIGTAIL
BRACKET
The Pigtail Bracket is used to mount the DB15 connector for easier user
access. The DB15 connector is used to make radio programming and
keyloading by the customer easier, eliminating the need to dismantle the radio
or Control Unit. There are two Pigtail brackets: one for use with the Control
Unit and one for use with the radio mounting bracket. The following sections
include procedures to mount the pigtail brackets in each of these
configurations.
10.3.1
Pigtail Bracket – Control Unit Mounting
For Control Unit mounting, the Pigtail Bracket is attached to the side of the
Control Unit bracket using existing mounting bracket hardware. The Pigtail
Bracket can be mounted to either the right or the left side of the Control Unit.
Hardware Kit, KT101533V6, contains Pigtail mounting bracket and hardware
required to attach Pigtail to bracket.
Summary of Contents for P5100 Series
