35
2.
Position the Pigtail Bracket with the connector facing away from the side
and towards the front of the radio. The Pigtail Bracket can be installed on
either side of the radio.
3.
Remove the first two radio mounting bracket screws and lockwashers
located closest to the front of the radio. Retain this hardware for Step 5.
4.
Align the bracket hole at the smaller end of the Pigtail Bracket with the
middle hole on the radio bracket and the corresponding hole in the radio
chassis. Insert an M5 x 10mm hex head screw and lockwasher.
5.
The other slot in the Pigtail Bracket will enable flexible positioning of the
pigtail. Position the bracket, and insert the remaining M5 x 10mm hex
head screw and lockwasher. Tighten both of the hex head screws to 7 N-
m (61 in-lb) to maintain the desired Pigtail position. See Figure 10-12.
Figure 10-12: Pigtail Bracket Mounted on Radio
10.4 SPEAKER
The speaker kit includes the speaker, mounting bracket and connecting cable.
Position the speaker toward the operator but follow the guidelines presented
on pages 5 through 14 to assure it does not present a hazard in the event of an
accident. The speaker may be mounted on the lower edge of the instrument
panel, the firewall or above the windshield in some trucks.
Summary of Contents for P5100 Series
