40
Figure 10-16: Remote Mounting Bracket Installation (50W TX and
Below)
1.
Using the bracket as a template, mark and drill the mounting holes using
a No. 27 drill. Be sure to leave enough room at the rear of the radio unit
for the cable connections.
2.
Secure the mounting bracket using four 1/4"-14 x 3/4" sheet metal screws
(use 1/4"-14 x 1" if needed). The bracket can be mounted so that it is
either above or below the radio for the user's convenience.
3.
Slide the radio unit into the bracket by aligning bracket guides with
grooves on each side of radio (rear of radio should be inserted first). Slide
radio back until screw holes in front of bracket align with screw holes in
side of radio. (Refer to Figure 10-15 or Figure 10-16 depending on radio
and bracket type.)
4. Secure radio to the bracket with M5 x 10 mm socket head screws
provided (7 N-m or 61 in-lb). There are three screws per side (6 total) for
Summary of Contents for P5100 Series
