42
11 DUAL CONTROL UNIT INSTALLATION
Dual Control units can be configured for either front mount or remote mount
radio units. Each configuration provides for a Main Control Unit and an
Auxiliary Control Unit. In the front mount dual control unit configuration, the
Main Control Unit is on the Radio Unit itself, with the Auxiliary Control Unit
located separately in a convenient location (see Figure 11-1A). In the remote
mount dual control unit configuration, the Main Control Unit is typically
located in the vehicle cab, with the Auxiliary Control Unit located separately
in a convenient location (see Figure 11-1B).
All radio units and control units in the Dual Control configuration
MUST BE
PROGRAMMED
prior to final installation. It is recommended that the units
be first programmed at an Authorized Service Center, and then transferred to
the user’s installation.
Figure 11-1: Dual Control Unit – Basic Configurations for
Front Mount (A) and Remote Mount (B) Installations
The Radio and Control Units must be programmed in a sequential procedure
to provide each Control Unit with the proper identification code.
Summary of Contents for P5100 Series
