55
6. Connect the Remote Mount Extended Option Accessory Cable
(19B802554P7) to the Auxiliary Control Unit and the Main Control Unit.
Please note: All extended option functions are only available at the
Main Control Unit.
7. A yellow ignition sense lead is provided on each control cable. If the
“Ignition Sense”
feature is enabled on the Radio Unit, it is necessary to
connect only one of the yellow leads provided, whichever is convenient.
Tape back the unused yellow lead. See page 29 for details.
8. Install the Speakers in convenient locations near the Radio Unit and
Auxiliary Control Unit. For special Remote Mount/Remote Mount
configurations that require both speakers to operate simultaneously
(parallel audio), refer to the configuration-specific parallel audio
installation instructions in Step 8.a. For typical speaker installation
proceed to Step 9.
8.a
Parallel Audio Installation – Remote Mount/Remote Mount
In special configurations that require both speakers to operate at the
same time (simultaneous audio), install the speakers for parallel audio
operation.
Refer to Figure 11-10 for the Parallel Audio Setup Installation.
Perform the following steps to install parallel audio speakers:
A.
Use the two 8
Ω
speakers, part number LS-102824-005, in place of
the two 4
Ω
speakers, part number LS102824V1.
B.
Hardwire each speaker directly (without relays) as shown in
Figure 11-9.
NOTE
It is very important to use the correct speakers for this
application, wiring 4
Ω
speakers in this configuration may cause
damage to the radio.
Summary of Contents for P5100 Series
