58
12 DUAL RADIO UNITS
The Dual Radio feature can be configured for two remote mount radio units or
for one front mount unit and one remote mount unit. In remote mount
configurations the Control Unit is typically located in the vehicle cab, with the
Radio Units located side-by-side in vehicle trunk. In front/remote mount
configurations the front mount unit is located in the vehicle cab, with the
remote mount unit located in a convenient location nearby. The remote/remote
mount configuration is the preferred installation, since a separate control unit
is required to program the remote unit in a front/remote mount configuration.
The following Dual Radio Unit configurations are not allowed:
•
Any configuration using a DIN cassette mount.
•
Any installation where Extended Options are required from both Radio
Units. Extended options are supported in one Radio Unit only.
Public Address (PA) Mode can be enabled or disabled
from the Master Radio Unit
ONLY
.
12.1 PRE-INSTALLATION
PROGRAMMING
PROCEDURE – DUAL RADIO UNITS
Both Radio Units in the Dual Radio configuration MUST BE
PROGRAMMED prior to final installation. It is recommended that the units
be first programmed at an Authorized Service Center, and then transferred to
the user's installation.
These configurations provide for a Master Radio Unit and a Slave Radio Unit.
In the remote/remote mount configuration, the Master Radio Unit is always
the radio most directly connected to the Control Unit. In the front/remote
mount configuration, the Master Radio Unit is always the front mount radio.
Extended Options are allowed only in the Master Radio Unit. Programming
each radio is straightforward, with one radio programmed as a Master radio
and one as a Slave radio.
1.
Decide which Radio Unit will be the Master Unit. Configure the radio for
programming as shown in the applicable maintenance manual.
2.
Program the Master Radio Unit (refer to Section 12.1.1).
a.
In the “Multi-Radio” field of ProGrammer, select “Master.”
b.
Select any M7100 keypad programming options if the keypad is to be
programmed. The M7100 keypad options can only be programmed with
“multi-radio” set to “Master” in a dual radio personality.
Summary of Contents for P5100 Series
