59
3.
Program the unit normally. Include Extended Option features, if purchased.
4.
Program the Slave Unit (refer to the programming configuration that
follows).
a.
Connect the Slave Radio Unit for programming. Be sure to use the
programming configuration for remote mount and supply the required
control unit for a front/remote mount dual radio configuration.
b.
In the “Multi-Radio” field of ProGrammer, select “Slave.”
5.
Program the unit normally. Do NOT include Extended Option features.
Both radio units are now ready for vehicular installation.
12.1.1 Programming
Configuration
NETWORK OPTIONS
Dual Control Setup:
Dual Control
Disable
Speaker Disable
Multiple Radio Setup:
Multiple Radio
Enable
Radio Type
Slave or Master
Power Up Volume
5
Mute Time-Out
30.0
Termination Enable
Master Radio Setup:
Display
Selected for Master radio only
Power Up
Enable for Master radio only
Power Up Radio
Master for Master radio only
Receive Emergency
Enable for Master radio only
Received Audio
Enable for Master radio only
Multiple Radio ProSound Settings:
MuRPS
Disable for Master radio only
To write the keypad file to the radio, specify the type of control unit. If the
control unit is a System model, place a check by the Write System Keypad
File control. If the control unit is a Scan model, place a check by the Write
Scan Keypad File control. If the wrong control is "Enabled", the control unit
Summary of Contents for P5100 Series
