60
will not work. Select Control Head ID. After selecting the keypad file, select
Load Saved Keypad Data or OK.
“Load Saved Keypad Data”
selection is available in
R19A (or later) ProGrammer.
12.2 INSTALLATION INSTRUCTIONS FOR
FRONT/REMOTE MOUNT DUAL RADIO
CONFIGURATION
1. Plan the mounting locations of the two Radio Units. Note that the maximum
cable length allowed between the two radios is two meters. Run Dual Radio
Cable (CA101288V10) between locations for Master and Slave Radio Units
(refer to Figure 12-1). Be sure to locate the P2/P3 connector assembly at the
Master Radio Unit.
2. After installing Master Radio Unit mounting hardware, connect the Dual
Radio Cable Connector (P3) to the Master Radio Unit. Tighten the two
jackscrews on P3. Next, connect the Accessory Cable (CA101288V2)
Connector (P1) to the Dual Radio Cable Connector (P2), and tighten to
jackscrews on P2.
3. Connect the Microphone and Accessories. Refer to Accessory Installation
Manual for proper connection of Accessories.
4. Connect Power Cable and Antenna then install Master Radio Unit in
mounting bracket.
Summary of Contents for P5100 Series
