65
12.4.2
Field Programming Procedure for Remote/
Remote Mount Dual Radio Configuration
The Radio and Control Units must be programmed in a sequential procedure
in order to provide each Control Unit with the proper identification code.
1.
Connect the M7100 Master Radio per the ProGrammer setup as shown in
Figure 12-4, STEP 1 with the Slave Radio disconnected. Program the
Master Radio with the control configurations per the Pre-Installation
Programming Procedure – Dual Radio Units and adjust as necessary for
the desired application.
2.
Connect the Slave Radio with ProGrammer as shown in Figure 12-4,
STEP 2. The Master Radio should now be disconnected, with the Slave
Radio connected as indicated. Program the Slave Radio with the
configuration per the Pre-Installation Programming Procedure – Dual
Radio Units and adjust as necessary for the desired application.
Summary of Contents for P5100 Series
