9
2.2.1 Mobile
Antennas
This device must not be co-located or operated in conjunction
with any other antenna or transmitter.
Install the radio’s antenna (refer to Table 2-1 for applicable antenna part
numbers) in the center of the vehicle’s roof. These mobile antenna
installation guidelines are limited to metal body motor vehicles or vehicles
with appropriate ground planes. The antenna installation should additionally
be in accordance with the following:
•
The requirements of the antenna manufacturer/supplier included with the
antenna.
•
Instructions in the M7100
IP
Radio Installation Manual, including
minimum antenna cable lengths.
•
The installation manual providing specific information of how to install
the antennas to facilitate recommended operating distances to all
potentially exposed persons.
Use only the M/A-COM approved/supplied antenna(s) or approved
replacement antenna. Unauthorized antennas, modifications, or attachments
could damage the radio and may violate FCC regulations.
2.2.2 Approved
Accessories
This radio has been tested and meets the FCC RF guidelines when used with
the M/A-COM accessories supplied or designated for use with this product.
Use of other accessories may not ensure compliance with the FCC’s RF
exposure guidelines, and may violate FCC regulations.
For a list of M/A-COM approved accessories refer to the product manuals,
M/A-COM’s Products and Services Catalog, or contact M/A-COM at 1-800-
528-7711.
2.2.3 Contact
Information
For additional information on exposure requirements or other information,
contact M/A-COM, Inc. at 1-800-528-7711 or at
http://www.macom-
wireless.com
.
Summary of Contents for P5100 Series
