MM23772, Rev. F
44
8.23.3
Scan Priority
The following lists the scan priority order (from highest to lowest):
•
Selected talk group in emergency state.
•
Default emergency group in emergency state.
•
Selected talk group.
•
Emergency capable group in emergency state.
•
Priority 1 talk group.
•
Priority 2 talk group.
•
Other (non-priority).
8.23.3.1 Change Scan Priority
1.
Press the
or
keys until “Priority1” or “Priority2” appears in the display (Priority1 group has
higher priority than the Priorty2 group).
2.
Press the
or
button until the desired talk group is displayed.
3.
Press the
key to select and activate the selection. The radio automatically returns to the Dwell
Display.
•
Changing the priority of a listen group does not change your talk group.
•
You set priority for two talk groups, but only in the selected profile.
•
The scanning priority settings are reset to the default values
when the radio is turned
off.
8.24 MAKE SELECTIVE CALLS
Selective calling is the capability for two voice radio units to obtain and use an independent talk path for a
private call. A properly equipped radio can initiate a selective call to any radio in the system that is also
programmed for selective calls.
In the OpenSky system, a radio can be configured to initiate selective calls through a pre-programmed list
in memory called a speed dial list. Alternatively, a properly equipped radio can initiate a selective call to
any radio in the system by entering the ten-digit User ID (similar to a telephone number) of the target
radio. Some radios are configured to only receive (not initiate) selective calls.
Selective calls are terminated if an emergency is declared. The network limits selective
calls to ten (10) minutes maximum.
If a Selective Call is attempted without registration, “No Priv” is displayed.
