MM23772, Rev. F
74
2.
Toggle Scan operation OFF by again pressing
(Scan model) or
(System model). will
disappear.
•
If the radio scans to a group other than the selected group then receives a call on the selected
group, the radio will switch to the selected group. However, if the “scanned-to” group is
programmed at a higher priority the radio will remain on the “scanned-to” group.
•
The radio will continue scanning if a new group is selected when scan is ON.
3.
Pressing the PTT button when scan is ON will cause the radio to transmit on the displayed group or to
the currently selected group (depending on programming).
9.20.2
Add Groups to a Scan List
Scan Model Radio:
1.
Scan must be OFF to add/delete groups to/from the scan list. If the Scan icon is ON, press the
key to turn Scan OFF.
2.
Select the desired group using the SYSTEM/GROUP/CHANNEL knob and/or the
or
keys. If
the selected group is currently on the list, pressing
will display on line three.
3.
If the scan list status icon is blank ( ), the group can be added to the scan list by pressing the
key.
will be displayed on line three.
4.
Press the
key a second time to set the group to Priority 2. A is displayed on line three.
5.
Press
a third time to set the group to Priority 1. A is displayed on line three. The priority level
section sequence only advances the group to the next high priority level and stops at priority level 1.
To select a lower priority level, the group must be deleted from the scan list and then added back to
the scan list. Each new group added to the scan list starts at the lowest priority. If the Priority 1 and
Priority 2 groups are already set and a new group is assigned as Priority 1 or Priority 2, the previously
assigned group will change to non-priority scanning. One of the following messages may be
momentarily displayed:
SCAN DIS
The radio is not programmed to scan.
FIXED P1
A Priority 1 group has been pre-programmed into the radio. A new Priority 1 group cannot
be selected.
FIXD LST
A fixed scan list has been pre-programmed into the radio. It is not possible to change the
list without reprogramming the radio.
To quickly view multiple group scan status, press
then slowly but consistently rotate
the group knob. Each group status will appear on the display.
System Model Radio:
1.
With scan operation turned OFF, select the desired group to add to the selected trunked system group
scan list.
